NEEDED:
Packet Finder/Editor, Artmoney and a clone account.
[For an ArtMoney Tutorial: Click Here]
HOW:
1.) Load up The Packet Finder/Editor.
2.) Go into the room you want to error and start logging the packets.
3.) Place a sticky in the room, preferably the lowest you can get it on the wall.
[Note: you have to put the poster down again in this exact spot so make the spot memorable]
4.) Search the Packets for a bit of code that says something like below:
[If you are NOT the room owner, miss out step 5]
5.) Now load up a clone and trade a sticky to it
6.) Drop the sticky in the EXACT same spot as last time but do NOT click "OK" to the "Are you sure?" message!
7.) Now go into ArtMoney and search your version of the ":w=9,8 l=45,100 l" packet.
8.) Change the packet to an invalid code like ":w=12345678901234"
[The code must be the same amount of characters as the packet]
9.) Now click "OK" to the message and it should snap to its new co-ordinates.
10.) Send "@Bfuse_furni_chooser" to the client and say :furni
11.) Find the sticky with no icon (the one you just made) and type something on it.
12.) Now click the "X" on the sticky and the room will error.
N1.) Each time you update the sticky it will error the room.
N2.) Change "AU" to " " in ArtMoney to create an anti-error.
- Tutorial was written by Alex (Shenk.)
Any errors in this tutorial should be emailed to or reported on the ShoutBox.
or reported on the ShoutBox.